Magnetrol 2xx Specifications download pdf (Page 4)

46-648 Jupiter Magnetostrictive Transmitters

1.0 Installation

Caution: If equipment is used in a manner not specified by manu-

facturer, protection provided by equipment may be

impaired

This section provides detailed procedures for properly

installing, wiring, configuring and, if needed, trouble-

shooting the Jupiter magnetostrictive level transmitter.

In most cases externally mounted units will be shipped

from the factory attached to the Orion Instruments

magnetic level indicator.

1.1 Unpacking

Caution: Do not rotate the Jupiter electronics enclosure or any

threaded fittings. Rotating the electronics enclosure will

void warranty and could cause damage to sensor cables.

Unpack the instrument carefully. Inspect all units for

damage. Report any concealed damage to carrier within

24 hours. Check the contents against the packing slip and

purchase order. Check and record the serial number for

future reference when ordering parts.

Caution: Do not discard the shipping container until all parts are

accounted for and inspected.

1.2 Electrostatic Discharge (ESD)

Handling Procedure

Magnetrol/Orion’s electronic instruments are manufac-

tured to the highest quality standards. These instruments

use electronic components that may be damaged by static

electricity present in most work environments.

The following steps are recommended to reduce the risk of

component failure due to electrostatic discharge.

• Ship and store circuit boards in anti-static bags. If an anti-

static bag is not available, wrap the board in aluminum

foil. Do not place boards on foam packing materials.

• Use a grounding wrist strap when installing and removing

circuit boards. A grounded workstation is recommended.

• Handle circuit boards only by the edges. Do not touch

components or connector pins.

• Make sure that all electrical connections are completely

made and none are partial or floating. Ground all equip-

ment to a good, earth ground.

1 2 3 4 5 6 7 8 9 ... 39 40

No comments

Magnetrol 2xx Specifications Page 4