Magnetrol 2xx Specifications download pdf (Page 7)

46-648 Jupiter Magnetostrictive Transmitters

3. Attach the lower clamp and tighten so that it remains in

place, but loose enough so that there is still room to place

the guide tab from the Jupiter between the inside of the

clamp and the outer diameter of the MLI chamber. See

Figure 1.

4. The upper clamp will need to be open to a large enough

diameter to be able to mount to the MLI as well as the

probe. The upper clamp should be positioned just above

the

⁄4" NPT threads. See Figure 2.

5. Mount the Jupiter guide pin in the lower clamp and tighten.

If necessary, use strapping tape to temporarily hold in

place on the MLI. See Figure 1.

6. Position the upper clamp to attach the unit to the MLI

and tighten. See Figure 1.

7. Discard any tape temporarily holding the Jupiter to the

MLI.

1.4.2 Internal, Direct Insertion

Use caution when handling probes to ensure probe is not

bent during installation. A bend in the probe may prevent

float from traveling freely up and down the probe.

Caution: Do not rotate the Jupiter electronics enclosure or any

threaded fittings. Rotating the electronics enclosure will

void warranty and could cause damage to sensor cables.

NOTE: Direct Insertion models may be calibrated prior to installation

by positioning the float at the desired 4 mA & 20 mA points.

See Section 1.6 for calibration details.

1. Verify float will pass through vessel opening, if not, it will

be necessary to attach the float after the probe is installed.

2. Carefully insert probe into vessel and thread or bolt to the

mating connection as appropriate.

3. The float is held on the probe by a C-clip inserted into a

groove machined into the tip of the probe. The float is

attached or removed by removing and reinserting the

C-clip. See figure 3. To ensure proper float orientation, the

float is marked “Up ”.

Bottom view

Figure 3

Float Attachment Detail

Figure 2

Upper Clamp

1 2 3 4 5 6 7 8 9 10 11 12 ... 39 40

No comments

Magnetrol 2xx Specifications Page 7